Installation How-To Archives - Page 4 of 4 - For The Workshop

January 4, 2020

Poppin’ Trunk…uh, Hood, I Mean.: How to Install a Pair of Redline Tuning Hood Struts [Step-By-Step Guide]

This was more of one of those gee-whiz mods I […]

0

December 28, 2019

Let’s Get Some of That Corn Flowing!: Flow 60% More Fuel With the XDI-60 High Pressure Fuel Pump & Innovate Motorsports Ethanol Content Gauge [Step-By-Step Guide]

Installed both the XtremeDI XDI-60 high pressure fuel pump and […]

0

October 25, 2019

Catch Me if You Can, Baby!: How to Install the UPR Products Dual-Valve Catch Can [Step-By-Step Guide]

Here is my spin, or should I say, variation, on […]

0

Kick Those Peasants Out of the Back Seats!: How to Remove the Power-Folding Third Row Seats and Save Over 90 LBS! [Step-By-Step Guide]

In my quest to get ever more lightweight, I decided […]

0

Is This Thing Even Real???!!!: How You Can Save 30 LBS Installing a Braille Lithium Ion Battery [Step-By-Step Guide]

One of the heavier components of the engine bay I […]

0

September 29, 2018

Let’s Open That Hole up…for Some Airflow!: How to Modify the Front Grille for Direct Air Into the Airbox [Step-By-Step Guide]

When I pulled off that piece of plastic that covers […]

0

September 20, 2018

Aftermarket Wheels v1.0…Nooiiice!: How to Save 104 LBS by Installing a Set of Volk Racing TE-37 Lightweight Wheels [Infographic]

After running stock 20″ Sport wheels with 25mm spacers for […]

0

September 19, 2018

Those Aren’t Brakes…These Are Some Brakes!: How I Saved 43 LBS With the TCE Performance Wilwood Brake Kit [Step-By-Step Guide]

This was a project that seemed daunting at first, but […]

0

Blue Oval? Booooorrriiing!: How to Replace the Front & Rear Ford Emblems [Infographic]

This was the very first modification I did to the […]

0

December 27, 2005

Mix & Match…Let’s Tango, Baby!: How to Integrate the Aquamist DDS3v1 & SMC Methanol Injection Kit [Step-By-Step Guide]

Gotta start off by apologizing first, this write up was […]

0